Autotek autocad raster design 2010 用户手册
4 Repeat step 3, or press Enter to exit the command.
NOTE When following an existing polyline, the 3D Polyline follower considers the
end nearest the point you picked as the start point, regardless of the original start
or endpoint for the polyline.
end nearest the point you picked as the start point, regardless of the original start
or endpoint for the polyline.
TIP Use raster snapping to make it easier to pick points on the raster entity you
are converting. For more information, see
are converting. For more information, see
(page 237).
Quick Reference
Menu
Image ➤ Vectorization Tools ➤ 3D Polyline Follower
Raster Design Toolbar
Command Line
vf3dpoly
Vectorizing Raster Text
You can replace raster text with vector text either by retyping the text or by
using automated text recognition tools.
using automated text recognition tools.
When retyping the text, you have a choice of two tools:
■
The Text tool can replace a single line of raster text with a single line of
AutoCAD text. You control the height, baseline angle, and justification
for the text entity.
AutoCAD text. You control the height, baseline angle, and justification
for the text entity.
■
The Multiline Text tool can replace multiple lines of raster text with a
block of AutoCAD multiline text (Mtext).
block of AutoCAD multiline text (Mtext).
Once you have entered the text for the Text or Multiline text tools,
ProdNameShort may prompt you to remove the original raster text. Use the
ProdNameShort may prompt you to remove the original raster text. Use the
(page 362) tab of the Raster Design Options dialog box to set
the method of removing this text.
Vectorizing Raster Text | 225