Autotek autocad raster design 2010 用户手册
■
Rub automatically rubs the underlying raster. This setting uses the
Rub/ Crop Line Width setting to determine the width of the raster it
rubs. For more information, see
Rub/ Crop Line Width setting to determine the width of the raster it
rubs. For more information, see
(page 266).
■
REM deletes the underlying raster. However, unlike the Rub setting,
this option recognizes raster line width and leaves raster intersections
intact.
this option recognizes raster line width and leaves raster intersections
intact.
NOTE The 3D Polyline Follower always uses the None option.
4 If you want the line, polyline, and arc tools to stop at vector intersections
during one-pick selection, then in the Line, Circle, Arc and Polyline
Settings section, select Stop at Vector Intersection. This is useful if much
of a drawing has been vectorized and the vectorization tools can depend
on increasing amounts of vector data to make stopping decisions.
Settings section, select Stop at Vector Intersection. This is useful if much
of a drawing has been vectorized and the vectorization tools can depend
on increasing amounts of vector data to make stopping decisions.
5 If you want the line and polyline tools to display a glyph that specifies
the start point, select Display Start Point Glyph.
6 In the Verification List section, select the type of values to appear in the
verification list:
■
Most Recently Used
■
Most Frequently Used
7 Specify the number of values to include in the verification list in the
Length box.
8 If you want SmartCorrect to respect current AutoCAD drafting settings
such as OSNAP, ORTHO, and POLAR, then in the SmartCorrect Settings
section select Respect Drafting Settings.
section select Respect Drafting Settings.
9 In the Correction Tolerance section, select one of the following options:
■
AutoCAD APERTURE uses the aperture settings from the Drafting tab
of the AutoCAD Options dialog box to determine how far (in screen
pixels) the resulting vector is allowed to shift in an attempt to respect
AutoCAD drafting settings.
of the AutoCAD Options dialog box to determine how far (in screen
pixels) the resulting vector is allowed to shift in an attempt to respect
AutoCAD drafting settings.
■
AutoCAD Units allows you specify how far (in AutoCAD units) the
resulting vector is allowed to shift in an attempt to respect AutoCAD
drafting settings. If you select this option, enter the number of units
in the text box.
resulting vector is allowed to shift in an attempt to respect AutoCAD
drafting settings. If you select this option, enter the number of units
in the text box.
10 If you want ProdNameShort to round the values for vector entities created
using one-pick selection, select Round Values. Rounding applies to the
General VTool Settings | 251