Autotek autocad raster design 2010 用户手册
REM Operations Toolbar
Related Procedure
Command-Line
Command
Command
Toolbar
Icon
Icon
(page 194)
ismooth
(page
191)
itrim
(page
191)
iextend
(page 192)
ifillet
(page 193)
ioffset
The Quick Bar
The Raster Design Quick Bar provides quick access to the settings you use most
often while performing REM or VTools operations. This toolbar is only available
when using the Map Classic Workspace.
often while performing REM or VTools operations. This toolbar is only available
when using the Map Classic Workspace.
The following settings can be toggled on and off on the Quick Bar:
Description
Name
Toolbar
Icon
Icon
Enables raster snap which allows you to
snap to raster objects.
snap to raster objects.
Raster Snap
Snaps to the center of a raster line. The
entire width of the line must be in the
snap window.
entire width of the line must be in the
snap window.
Raster Snap Center
Snaps to the end of a raster line.
Raster Snap End
Note When a line ends because it inter-
sects with another line, this is considered
an intersection, not an end point.
sects with another line, this is considered
an intersection, not an end point.
298 | Appendix A Troubleshooting and Reference Guide