HP ml310 用户手册

 

  CAUTION:  Back up any data stored on the hard drives before 

proceeding. The configuration process erases all data on the hard 
drives. 

1.

  Power up the server. Press the F9 key to launch RBSU. 

  NOTE:  Enabling the RAID option in RBSU is only necessary for 

installation of the RAID driver. If this option is not enabled, the OS loads 
the standard ATA driver from the OS media. 

2.

  Select Advanced Options>SATA Software RAID>Enable RAID. 

3.

  Press the F10 key twice to exit RBSU. The system automatically reboots. 

4.

  After the system reboots, press the F8 key to activate the embedded SATA 

RAID controller. 

5.

  Select Array Configuration Utility from the Option menu. 

6.

  Select Configure Drives from the main menu. 

7.

  Press the INS key twice to select the two SATA drives.   

8.

  Press the Enter key to complete selection. The system prompts a selection of 

RAID 0 or RAID 1. 

9.

  Select a RAID level. 

10.

 Enter an Array Label. If RAID 0 is selected, select a Stripe Size. 

11.

 Select Create RAID: 

RAID 0 

No Init – Creates array without initialization 

RAID 0 

Migrate* – Creates RAID 0 from a single drive 

RAID 1 

Quick Init - Creates array without initialization 

RAID 1 

Clear* – Writes zeroes to all the array members 

RAID 1 

Build* – Copies data from source drive to target 
drive. 

 

*The process can take 30 minutes or more to complete depending on the drive capacity. 

12.

 After the configuration is complete, select Done.