HP pl4245n 用户手册

    Introduction 

Indicator light 

The red light blinks once each time a button is 
pushed. If the red light blinks two times when a 
button is pushed, the remote control batteries are 
low and need replacement. 

Setup 

Use the SETUP button when programming the 
remote control for component control; see 
“Programming the remote control for component 
control“ on page 33. 

PWR 

Press PWR once to turn on or off the selected home 
entertainment component.  

TV, CBL/SAT, 
DVD/VCR, or 
HP.PC 

Press one of these buttons once to select a home 
entertainment component to control, and then point 
the remote control at the component. 

HP.PC selects the HP Media Center PC (connected 
to the VGA or DVI connector) and enables the HP 
MCPC special buttons on the remote. Refer to 
“Using the HP MCPC with the TV remote control“ on 
page 18 for more information. 

To program the remote control to operate a cable or 
satellite set-top-box or a DVD or VCR; see 
“Programming the remote control for component 
control“ on page 33. 

Keypad 

Use the keypad (0 ~ 9, +100) to directly select 
channels. 

Mute 

Press MUTE once to turn sound off or on. 

VOL 

Use VOL+ (or VOL–) to raise (or lower) the sound 
volume. 

CH. RTN 

Press CH. RTN (channel return) once to recall the 
last channel or to page back one screen in the main 
menu. 

HP.MC 

Press HP.MC to start Media Center when using the 
HP Media Center PC. 

CH 

Use CH+ (or CH–) to select the next higher (or 
lower) channel. 

Selects TV as the input source. 

Guide/P. Mode 

Use GUIDE to display the program guide for a TV 
set-top-box or for HP MCPC. Use Picture mode to 
scroll through the three picture modes Standard, 
Movie, or Dynamic. 

EXIT/Back 

Use EXIT to exit out of the selected component’s 
menu or guide. 

Use Back for the HP MCPC.