HP qms 1660 用户手册
Storage
Options
QMS 1660 Print System Reference
6-50
»
Note:
Before installing an internal IDE hard disk, you must have an
optional IDE-SCSI board.
If you’re installing an optional IDE-SCSI board for the first time,
refer now to “IDE-SCSI Board,” earlier in this section, for installation
instructions. You will be referred to these instructions at the
appropriate time.
refer now to “IDE-SCSI Board,” earlier in this section, for installation
instructions. You will be referred to these instructions at the
appropriate time.
If the IDE-SCSI board is already installed, you must remove it
before you can install an internal hard disk. Refer to the same section
for information on removing the board.
before you can install an internal hard disk. Refer to the same section
for information on removing the board.
1
Connect one end of the plastic ribbon cable to the hard disk.
Align the colored stripe on the cable with pin 1 on the hard disk
connector, and then slowly push the cable onto the connector.
connector, and then slowly push the cable onto the connector.
▲
Caution:
The plastic ribbon cable is fragile. Handle it gently.
Pin 1