Canon canoscan 8800f 用户手册

9

 

c

Align the Film Guide’s tab with the FILM symbol on the document glass of the scanner.

d

Place a slide or slides face down (correctly viewed from 
below) in the Film Guide as shown in the diagram to the 

right.

 

c

Open the film holder on the film guide, place the film face 
down and close the film holder.

d

Align the Film Guide’s tab with the FILM symbol on the 
document glass of the scanner.

Close the document cover.

• Leave a gap of 5 mm or greater between film 

strips when placing two or more on the 
document glass.

• Ensure that there is no gap between the 

edge of the film and the film guide on the 
side near the calibration slot.

Using a Film Retainer Sheet
Curled film strips can stick to the document glass 

and cause a pattern of rings called Newton Rings to 

appear on the scanned image. If this occurs, scan 

using the supplied film retainer sheet as shown in 

the diagram.

(A) Scan with the film retainer sheet inserted 

beneath the film.

(B) If Newton Rings still appear after following 

Instruction (A), turn the film strip over and place 
it in the film holder with the film retainer sheet on 
top so that the film edges are held down for 
scanning. Then preview the image in ScanGear 
and click the [Mirror] button to reverse the image 
before initiating the final scan.

To avoid damaging the film, always place the 
glossy side (the side without an illustration) 
of the film retainer sheet against the film.

Film Holder

With its glossy side 
facing upward, slip 
the film retainer 
sheet under the film.

Hold the film edges down 
by placing the film 
retainer sheet on top with 
its glossy side facing 
downward. 

120 Format Film

Film retainer 
sheet