Canon imagerunner c3380 用户手册

Settings Menu

Pr

inter Settings Menu

■ Offset Short Edge/Offset Long Edge (Back)

-2.00 to +2.00 inches (in increments of 0.01 inches); 0.00

*

 inches

This setting enables you to set the offset position. The settings can be set in 
increments of 0.01" (0.5 mm) from -2.00" (-50.0 mm) through +2.00" (+50.0 mm).

The print position on the back page is adjusted in the vertical or horizontal 
direction to the value specified in the setting value.

To adjust the print position on the front page, set 'Offset Short Edge/Offset Long 
Edge (Front)' (the previous setting).

You can increase or decrease the setting in increments of 0.01" (0.5 mm) to 
adjust the print position, as described below.

Offset Short Edge (Back): Increasing the setting value moves the image in the 
rightward X direction on the paper. Decreasing the setting value moves the image 
in the leftward X direction on the paper.

Offset Long Edge (Back): Increasing the setting value moves the image in the 
downward Y direction on the paper. Decreasing the setting value moves the 
image in the upward Y direction on the paper.

IMPORTANT

 

Please note that if the print position is adjusted to place print data outside the 
printable area, the portion outside the printable area is not printed.

NOTE

 

•

If this setting is used in combination with 'Margin', the values of the two settings are 
added together.

•

Pressing [ 

 ] increases the setting value by 0.01" (0.5 mm) each time the key is 

pressed. Pressing [ 

 ] decreases the value by 0.01" (0.5 mm) each time. Holding 

down either [ 

 ] or [ 

 ] continuously speeds up the value alteration.

DEF

DEF

X

Y

Adjust using 

X/Y-Adjustment

Area adjusted using 

Y-Adjustment

[+]

Area adjusted using
X-Adjustment

[+]

Back

Back

Part of the
original margin