Canon pixma ip4300 用户手册

页码 102
64
Troubleshooting
Print Results Not Satisfactory
„
Cannot Print to End of Job
„
Part of the Page Is Not Printed
„
Ink Does Not Come Out/Printing Does Not Start/Printing Is Blurred/
Colors Are Wrong/Straight Lines Are Misaligned
Cause
Action
Size of the print data is extremely large 
(Windows XP/Windows 2000 only).
In Windows XP and Windows 2000, click Print Options on the Page Setup 
sheet. Then, select the Reduce spool data size check box in the displayed 
dialog.
Selecting Reduce spool data size may reduce the print quality.
Cause
Action
Page Size setting in the printer driver 
does not match the actual size of the 
paper loaded in the printer.
If the Page Size setting, set in the application software you are printing from or 
in the printer driver, does not match the actual size of the printing paper, part of 
the page may not be printed.
Check the page size setting in your application. Then, check Page Size on the 
Page Setup sheet in the printer properties dialog box of the printer driver 
(Windows) or the Page Setup dialog box of the printer driver (Macintosh).
You are performing automatic duplex 
printing.
When performing automatic duplex printing, the printable area at the top of the 
page will be 0.08 inches / 2 mm narrower than the usual. For this reason, the 
bottom of the page may not be printed. To prevent this, select Use reduced 
printing
 from the printer driver.
Important
Reduced printing may affect the layout depending on your document.
(1)Open the printer properties dialog box.
(2)Click Print Area Setup in the Page Setup sheet and select Use reduced 
printing.
(1)Open the Print dialog box.
(2)Select Duplex Printing & Margin in the pop-up menu.
(3)Select Automatic Duplex Printing and click Use reduced printing in Print 
Area.
Cause
Action
Ink tank is empty.
Open the Top Cover and check the ink lamps.
If an ink lamp is flashing red slowly at about 3-second intervals, ink is running 
low. If an ink lamp is either flashing red fast at about 1-second intervals or is not 
lit, the tank is empty.
Replace the ink tank, and close the Top Cover.
See “Replacing an Ink Tank” on page 26.
Note
For details on different flashing speeds, see “Replacing an Ink Tank” on 
page 26.
downloadlike
ArtboardArtboardArtboard
Report Bug