Samsung SRP-275 用户手册
Rev. 1.04
- 19 -
SRP-275
• Memory Switch 8
Switch
Function
On
Off
1 Upside
down
On
Off
2
Font Selection
Font B
Font A
3
Selection Paper End Buzzer
Off
On
4
Reserved
Fixed to Off
5
Selection of the cover open status
Cover open
Paper end
6
Buffer Size
40 bytes
8 Kbytes
7
Receive buffer full release
Remaining 522 bytes
Remaining 640 bytes
8
Printer (Cover open during operation)
Errors that can
possibly recover
possibly recover
Errors that
automatically recover
automatically recover
NOTES
MSW 8-5:
When Off is selected, a bit of the “paper end sensor” in each status that is transmitted from the printer is
changed every time the rear cover is open or closed. When On is selected, a bit of the “rear cover open /
changed every time the rear cover is open or closed. When On is selected, a bit of the “rear cover open /
close" in each status that is transmitted from the printer is changed every time the rear cover is open or
closed. When you replace a SRP-270 with a SRP-275, you should adjust the MSW 8-5 to Off.
MSW 8-8:
When Off is selected, a bit of the “automatic recoverable error” in each status that is transmitted from
MSW 8-8:
When Off is selected, a bit of the “automatic recoverable error” in each status that is transmitted from
the printer is changed every time the rear cover is open. When On is selected, a bit of the “mechanical
error” in each status that is transmitted from the printer is changed every time the rear cover is open.
The setting of MSW 8-5 and 8-8 can be set by “Memory Switch setup mode”.
The setting of MSW 8-5 and 8-8 can be set by “Memory Switch setup mode”.
• Customize value
Function
Selectable value
Paper roll width
57.5 mm / 69.5 mm / 76 mm (default value)
NOTES
These setting can be set by “Memory Switch setup mode.”
• Serial communication
Function
Selectable value
2400 bps
4800 bps
baud rate
9600 bps
19200 bps
None Odd
Parity
Even -
Handshake DSR/DTR
XON/XOFF
Data length
7 bit
8 bit
NOTES
There are two methods, DIP Switch and Memory Switch, to adjust the serial communication conditions.
DIP Switch 1-5 selects which is effective, DIP Switch or Memory Switch.
To enable the “Serial communication“ setting, you have to adjust the “Serial interface selection“ function
To enable the “Serial communication“ setting, you have to adjust the “Serial interface selection“ function
of DIP Switch 1-5 to “Memory Switch”.
These settings can be set by “Memory Switch setup mode”.