Sony 3-289-450-45(1) 用户手册

Measurement starts in 5 seconds. A count 
down is displayed.
The measurement process will take 
approximately 30 seconds to complete.
The table below shows the display when 
measurement starts.

• Operations other than turning the receiver on or off 

are deactivated during the measurement.

• The measurements may not be performed correctly 

or Auto Calibration cannot be performed when 
special speakers, such as dipole speakers are used.

The Auto Calibration function will be 
canceled when you do the following during the 
measurement process:
– Press ?/1 or POWER on the receiver.
– Press the input buttons or turn the INPUT 

SELECTOR on the receiver.

– Change the volume level.
– Press MUTING.
– Change the setting of the SPEAKERS (OFF/

A/B/A+B).

– Connect headphones.
– Press  AUTO  CAL  again. 

When the measurement ends, a beep 
sounds and the measurement result 
appears on the display.

V/v 

Speaker existence

TONE

Speaker gain, distance, frequency 
response

T.S.P.

Subwoofer gain and distance

WOOFER

When the 
measurement 
process 
completes 
properly

SAVE EXIT Proceed to step 

2.

When the 
measurement 
process fails

E - 

xxx

:

xx

See “Message 
list after Auto 
Calibration 
measurement” 
(page 35).

EXIT

Exits the setting process 
without saving the 
measurement results.

LEVEL INFO.

Displays the measurement 
result for speaker level.

DIST. INFO.

Displays the measurement 
result for speaker distance.

PHASE INFO.

Displays the phase of each 
speaker (in phase/out of 
phase). See “When you 
select “PHASE INFO.”” 
(page 34).

WARN CHECK Displays warning 

concerning the 
measurement results. See 
“When you select “WARN 
CHECK”” (page 36).

SAVE EXIT

Saves the measurement 
results and exits the setting 
process.

RETRY

Performs the Auto 
Calibration again.