Sony 4-269-996-e5(1) 用户手册

GB

Connect the TV to your AC power 
outlet (mains socket).

Press 1 on the TV. The = (power) 
indicator will light up in green.

When you switch on the TV for the first 
time, the Language menu appears on the 
screen.

~
• When you turn on the TV for the first time, the 

TV requires some internal processing for 
optimization before you can perform the 
initial setup. There will be no picture and 
sound, and the timer indicator on the front of 
the TV blinks orange for about 40 seconds. Do 
not turn off the TV during this process.
This process has been completed at the factory 
for some TVs. 

Follow the instructions on the screen.

Satellite Auto Tuning: 
The following procedures may be required 
depending on the area:

Please select “Preferred Satellite” or 
“General Satellite”.

For “Preferred Satellite”, select your 
preferred operator.

“Satellite Auto Tuning” automatically 
tunes in available satellite channels. Digital 
Satellite Equipment Control (DiSEqC) 1.0 
management allows setting of up to four 
different channels. The following settings 
are independent for each connection. To 
set-up DiSEqC input in the “DiSEqC 
Control”, use “LNB Configuration”.

1 “Scan Type” and “Advanced Settings” 
(for common satellite setting- Satellite 1 
to 4):
Allows you to set tuning settings in more 
detail to better find the type of services you 
would prefer to tune.
“Scan Type”: If no channel is found using 
“Network Scan”, try “Full Scan”.

“Full Scan”: Performs a complete 
frequency scan and guarantees tuning to 
all possible programmes for the currently 
set LNB configuration. Previously-tuned 
programmes will be lost.
“Network Scan”: Performs a scan in the 
transponders of a network (aka NIT 
scan). Since “Network Scan” is faster 
than “Full Scan”, it is recommended 
when tuning to a known network 
(normally associated with a satellite). A 
transponder must be specified, from 
which network information (other 
transponders) will be retrieved. 
Previously-tuned programmes will be 
lost.

2 “LNB Configuration” (for each satellite 
setting- Satellite 1 to 4):
In the case of a non-standard LNB (low-
noise block), manual setting is available.

– In the case of a single satellite channel, 

you can leave it on the initial setting.

– For two satellite channels, you need to 

set “Toneburst A” (1st satellite) and 
“Toneburst B” (2nd satellite) in the 
“DiSEqC Control” setting.

Except KDL-46/40/
32CX52x

KDL-46/40/32CX52x