Sony LBT-XG60 用户手册
27
Additional Information
Speakers
“PROTECT” and “PUSH POWER” appear
alternately.
alternately.
• A strong signal was input. Press ?/1 to turn off
the power, leave the system turned off for a
while, then press ?/1 again to turn on the power.
while, then press ?/1 again to turn on the power.
• Check the speaker cables in case “PROTECT”
and “PUSH POWER” appear alternately again
after you turn the system on.
after you turn the system on.
Sound comes from one channel or unbalanced
left and right volume.
left and right volume.
• Check the speaker connection and speaker
placement.
CD Player
The CD tray does not close.
• The CD is not placed properly.
The CD will not play.
• The CD is not lying flat in the disc tray.
• The CD is dirty (see “Notes on CDs ” on page
25).
• The CD is inserted label side down.
• The CD is moist.
Play does not start from the first track.
• The player is in program or shuffle mode. Press
PLAY MODE repeatedly until “PROGRAM,”
“ALL DISCS SHUFFLE,” or “1 DISC
SHUFFLE” disappears.
“ALL DISCS SHUFFLE,” or “1 DISC
SHUFFLE” disappears.
Tape Deck
The tape does not record.
• The tab has been removed from the cassette (see
“To save a tape permanently” on page 25).
• The tape has reeled to the end.
The tape does not record nor play, or there is a
decrease in sound level.
decrease in sound level.
• The heads are dirty (see “Cleaning the tape
heads” on page 25).
• The record/playback heads are magnetized (see
“Demagnetizing the tape heads” on page 25).
The tape does not erase completely.
• The record/playback heads are magnetized (see
“Demagnetizing the tape heads” on page 25).
There is excessive wow or flutter, or the sound
drops out.
drops out.
• The capstans or pinch rollers are dirty (see
“Cleaning the tape heads” on page 25).
Noise increases or the high frequencies are erased.
• The record/playback heads are magnetized (see
“Demagnetizing the tape heads” on page 25).
Tuner
Severe hum or noise (“TUNED” or “STEREO”
flashes in the display).
flashes in the display).
• Adjust the antenna.
• The signal strength is too weak. Connect the
external antenna.
A stereo FM program cannot be received in stereo.
• Press STEREO/MONO so that “STEREO”
disappears.
If other troubles not described above
occur, reset the system as follows:
1
Press
c
/CLOCK SET, ENTER/NEXT and
?/1
at the same time.
2
Unplug the power cord.
3
Plug the power cord back in.
4
Press
?/1
to turn on the power.
The unit is reset to factory settings. All the
settings you made are cleared.
settings you made are cleared.