Sony MZ-R410 用户手册

下载
页码 64
52
Messages
If the following messages flash in the display window, check the messages below.
Error message Meaning/Remedy
BLANK
• An MD with no recording on it is inserted.
BUSY
• You tried to operate the recorder while it was accessing the recorded 
data. 
, Wait until the message goes out (in rare cases, it may take a few 
minutes).
Edit
• The MD player is recording information (track start and end 
position) from the memory to the disk. 
, Wait until this process is completed. Do not expose the player to 
physical shock, nor disrupt power supply.
ERROR
• Recording was not correctly done.
, Place the recorder at a place with no vibrations and record again.
• The disc is soiled with an oil film or finger prints, is scratched, or is 
not a standard disc.
, Try recording again with another disc.
• The recorder cannot read the disc information correctly.
, Reinsert the disc.
• The recorder cannot read the disc information correctly.
, Insert another disc.
, If it is no problem to erase the entire disc, do so (page 42).
FULL
• The remaining recording time on the disc is 12 seconds (stereo), 24 
seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less.
, Replace the disc.
• You tried to enter more than 200 letters to label a single track or disc. 
• You tried to enter a total of more than 1,700 letters for track or disc 
names. 
, Enter a shorter name for the track, group, or disc (page 34), or set 
the “LPStmp” setting to “OFF” so that “LP:” is not added at the 
beginning of the track name (page 22).
HiDCin
• Voltage of the power supply is too high (The supplied AC power 
adaptor or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car 
battery cord.
HOLD
• The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder (page 12).
LoBATT
• Battery is weak. 
, Replace the dry battery (page 11).
MEMORY
• You tried to record with the recorder placed where it receives 
continuous vibration.
,  Put the recorder on a stable place, and start recording again.