Sony rdr-hx725 用户手册

下载
页码 124
113
Add
iti
on
al
 I
n
fo
rm
at
io
n
The disc tray does not open and 
“LOCKED” appears in the front panel 
display.
, The disc tray is locked. Cancel the Child 
The disc tray does not open and “TRAY 
LOCKED” appears in the front panel 
display.
, Contact your Sony dealer or local 
authorized Sony service facility.
The disc tray does not open and you 
cannot remove the disc after you press 
Z
(open/close).
, Turn off the recorder. Once the clock 
appears in the front panel display, 
disconnect the mains lead. (If the recorder 
does not turn off or if the clock does not 
appear in the front panel display, disconnect 
the mains lead anyway.) Connect the mains 
lead again while pressing down 
A on the 
recorder, and release the button when the 
disc tray opens. Then, keep 
[/1 on the 
recorder pressed for about ten seconds until 
“WELCOME” appears in the front panel 
display.
“RECOVERY” appears in the front panel 
display.
, The recorder’s recovery function was 
activated when the recorder was turned on 
because the power was turned off or failed 
during recording. Leave the recorder on 
until “RECOVERY” disappears from the 
front panel display.
“HDD ERROR” appears in the front panel 
display.
, The hard disk error occurred. Press down 
[/1 on the recorder for ten seconds until 
“WELCOME” appears in the front panel 
display. If this does not resolve the problem, 
format the recorder’s HDD by pressing 
down the HDD button on the recorder for 
more than ten seconds until “FORMAT” 
appears in the front panel display. Note that 
all the contents recorded on the HDD will 
be erased. If this does not fix the problem, 
contact your nearest Sony dealer.
“FAN ERROR” appears in the front panel 
display.
, Check that the vent on the rear of the 
recorder is not blocked. Then, immediately 
disconnect the mains lead. Leave the 
recorder off for a while, then re-connect the 
mains lead, and press 
[/1 on the recorder.
Mechanical sound is heard when the 
recorder is off.
, While the recorder is adjusting the clock for 
the Auto Clock Set function or scanning the 
programme positions for the PDC/VPS 
function, operational noises (such as the 
internal fan) may be heard, even when the 
power is off. This is not a malfunction.