Sony STR-DH810 用户手册

 

 

 

 

 

 

 

 

 

• Select the appropriate input using the input 

buttons.

• Set your TV to the appropriate input mode.
• Move your audio components away from 

the TV.

• Assign the component video input 

correctly.

• Depending on the DIGITAL MEDIA 

PORT adapter, video output may not be 
possible.

• Check that the components are connected 

correctly.

• Select the source component using the 

input buttons (page 43).

• Use a 75-ohm coaxial cable (not supplied) 

to connect the receiver to an outdoor FM 
antenna (aerial) as shown below. If you 
connect the receiver to an outdoor antenna 
(aerial), ground it against lightning. To 
prevent a gas explosion, do not connect the 
ground (earth) wire to a gas pipe.

• Check that the antennas (aerials) are 

connected securely. Adjust the antennas 
(aerials) and connect an external antenna 
(aerial), if necessary.

• The signal strength of the stations is too 

weak (when tuning in with automatic 
tuning). Use direct tuning.

• Make sure you set the tuning interval 

correctly (when tuning in AM stations 
with direct tuning).

• No stations have been preset or the preset 

stations have been cleared (when tuning 
by scanning preset stations). Preset the 
stations (page 48).

• Press AMP, then press DISPLAY 

repeatedly on the remote so that the 
frequency appears on the display.

• Make sure that you are tuned to an FM 

RDS station.

• Select a stronger FM station.

• Contact the radio station and find out 

whether they actually provide the service 
in question. If so, the service may be 
temporarily out of order.

* Models of area code CEL, CEK only.

AM

Receiver

To ground

Ground (earth) 
wire (not 
supplied) 

Outdoor FM antenna (aerial)