Sony STR-DG700 用户手册
79
GB
C:\Documents and
Settings\pc13\Desktop\JC060016_2680065111DG700_GB\2680065111\GB06ENJ_STR-DG700-
CEL.fm
Settings\pc13\Desktop\JC060016_2680065111DG700_GB\2680065111\GB06ENJ_STR-DG700-
CEL.fm
masterpage: Right
STR-DG500
2-662-258-12 (1)
Ad
dition
dition
al I
n
n
fo
rm
atio
n
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna as shown below. If you connect
the receiver to an outdoor antenna, ground
it against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.
antenna as shown below. If you connect
the receiver to an outdoor antenna, ground
it against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.
Radio stations cannot be tuned in.
• Check that the antennas are connected
securely. Adjust the antennas and connect
an external antenna, if necessary.
an external antenna, if necessary.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 60).
scanning preset stations). Preset the
stations (page 60).
• Press DISPLAY repeatedly on the receiver
so that the frequency appears on the
display.
display.
RDS does not work.*
• Make sure that you are tuned to an FM
RDS station.
• Select a stronger FM station.
The RDS information that you want
does not appear.*
does not appear.*
• Contact the radio station and find out
whether they actually provide the service
in question. If so, the service may be
temporarily out of order.
in question. If so, the service may be
temporarily out of order.
There is no picture or an unclear
picture appears on the TV screen or
monitor.
picture appears on the TV screen or
monitor.
• Select the appropriate input using the input
buttons.
• Set your TV to the appropriate input mode.
• Move your audio components away from
• Move your audio components away from
the TV.
• Assign the component video input
correctly.
The source image input to the HDMI
jack on the receiver is not output from
the TV.
jack on the receiver is not output from
the TV.
• Check the HDMI connection.
• Depending on the playback component,
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with the each component.
Refer to the operating instructions
supplied with the each component.
• Assign the HDMI input correctly.
The MULTI CHANNEL DECODING lamp
does not light up in blue.
does not light up in blue.
• Check that the playback component is
connected to a digital jack and the input is
selected properly on this receiver.
selected properly on this receiver.
• Check whether the input source of the
software being played back corresponds to
the multi channel format.
the multi channel format.
• Check whether the setup on the playback
component is set to multi channel sound.
ANTENNA
AM
Receiver
To ground
Ground wire
(not supplied)
(not supplied)
Outdoor FM antenna
continued
GB01COV_STR-DG700-CEL.book Page 79 Wednesday, February 15, 2006 4:11 PM