Sony STR-DV10 用户手册
Ad
dition
dition
al I
n
n
fo
rm
atio
n
masterpage:Right
lename[E:\SEM_Janet\Revision1_STR-
DV10\J9050000_2560573121_US\2560573121\US09ADD_STR-DV10-U.fm]
49
US
model name1[STR-DV10]
[2-560-573-12(1)]
The surround effect cannot be obtained.
• Make sure the sound field function is on (press
MOVIE or MUSIC).
• Sound fields do not function for the signals with a
sampling frequency of more than 48 kHz.
Dolby Digital or DTS multi channel sound is
not reproduced.
not reproduced.
• Check that the playing DVD, etc. is recorded in
Dolby Digital or DTS format.
• When connecting the DVD player, etc. to the
digital input jacks of this receiver, check the audio
setting (settings for the audio output) of the
connected component.
setting (settings for the audio output) of the
connected component.
Recording cannot be done.
• Check that the components are connected
correctly.
• Select the source component with input buttons.
• Make sure that INPUT MODE is set to
• Make sure that INPUT MODE is set to “COAX
IN” or “OPT IN” (page 35) before recording from
a digital component connected to the DIGITAL
OPTICAL MD/TAPE OUT jack.
a digital component connected to the DIGITAL
OPTICAL MD/TAPE OUT jack.
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied) to
connect the receiver to an outdoor FM antenna as
shown below. If you connect the receiver to an
outdoor antenna, ground it against lightning. To
prevent a gas explosion, do not connect the ground
wire to a gas pipe.
shown below. If you connect the receiver to an
outdoor antenna, ground it against lightning. To
prevent a gas explosion, do not connect the ground
wire to a gas pipe.
Radio stations cannot be tuned in.
• Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
antenna if necessary.
• The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use direct
tuning.
tuning.
• Make sure you set the tuning interval correctly
(when tuning in AM stations with direct tuning).
• No stations have been preset or the preset stations
have been cleared (when tuning by scanning
preset stations). Preset the stations (page 26).
preset stations). Preset the stations (page 26).
• Press DISPLAY repeatedly so that the frequency
appears in the display.
There is no picture or an unclear picture
appears on the TV screen or monitor.
appears on the TV screen or monitor.
• Select the appropriate input on the receiver.
• Set your TV to the appropriate input mode.
• Move your audio components away from the TV.
• Connect your TV to the receiver using the same
type of connecting cord as the one used to connect
the receiver and video component (pages 8 and
11).
the receiver and video component (pages 8 and
11).
The DIGITAL OPTICAL MD/TAPE OUT jack
flashes red.
flashes red.
• When “AUTO IN” is selected for INPUT MODE,
the jack flashes red when no digital audio signal is
input. This depends on the INPUT MODE
function, and is not a malfunction.
input. This depends on the INPUT MODE
function, and is not a malfunction.
AM
ANTENNA
Receiver
To ground
Ground wire
(not supplied)
(not supplied)
Outdoor FM antenna
continued
US01COV_STR-DV10-U.book Page 49 Monday, July 4, 2005 11:52 AM