Sony str-lsa1 用户手册

2

Should any solid object or liquid fall into
the cabinet, unplug the receiver and have it
checked by qualified personnel before
operating it any further.

• Before operating the receiver, check that

the operating voltage is identical with
your local power supply. The operating
voltage is indicated on the nameplate at
the bottom of the receiver.

• The unit is not disconnected from the AC

power source (mains) as long as it is
connected to the wall outlet, even if the
unit itself has been turned off.

• If you are not going to use the receiver

for a long time, be sure to disconnect the
receiver from the wall outlet. To
disconnect the AC power cord, grasp the
plug itself; never pull the cord.

• AC power cord must be changed only at

the qualified service shop.

• Do not install the appliance in a confined

space, such as a bookcase or built-in
cabinet.

• Place the receiver in a location with

adequate ventilation to prevent heat
buildup and prolong the life of the
receiver.

• Do not place the receiver near heat

sources, or in a place subject to direct
sunlight, excessive dust or mechanical
shock.

• The nameplate is located on the bottom

exterior.

Before connecting other components, be
sure to turn off and unplug the receiver.

Clean the cabinet, panel and controls with
a soft cloth slightly moistened with a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder or solvent
such as alcohol or benzine.

Slide out and remove the battery case, and
insert a new lithium battery CR2025 with
the + side facing up.  And then, slide the
battery case back in.

1

2

1

Keep pushing.

2

Pull out.

Danger of explosion if battery is incorrectly
replaced.  Replace the battery only with
the same or equivalent type recommended
by the manufacturer.  Discard unused
batteries according to the manufacturer’s
instructions.

If you have any question or problem
concerning your receiver, please
consult your nearest Sony dealer.