Sony STR-DG1100 用户手册
122
GB
are output from the VIDEO jack. Input
480i component video signals.
480i component video signals.
• When component input signals other than
480p are output, use the COMPONENT
VIDEO OUT jack and set “Resolution” to
“DIRECT.”
VIDEO OUT jack and set “Resolution” to
“DIRECT.”
Images of the source with HDMI
connection is not output to the TV.
connection is not output to the TV.
• Make sure that cables are correctly and
securely connected to components.
• Depending on the playback component,
component may need to be set up. Refer to
the operating instructions supplied with
the each component.
the operating instructions supplied with
the each component.
Recording cannot be carried out.
• Check that the components are connected
correctly (page 25).
• Select the source component using INPUT
SELECTOR (page 49).
The GUI does not appear on the TV
screen.
screen.
• Press SHIFT, then press MENU to show
“GUI MODE” on the display.
• Check the TV is connected correctly.
Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
(aerials) and connect an external antenna
(aerial), if necessary.
• Keep the satellite radio antenna, away
from the speaker cords and the power cord
to avoid picking up noise.
to avoid picking up noise.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 77).
scanning preset stations). Preset the
stations (page 77).
• Press DISPLAY so that the frequency
appears on the display.
The system cannot receive satellite
channels at all.
channels at all.
• The receiving condition is not good. Move
the antenna to the place where the
condition is good.
condition is good.
• Check that you subscribed to the desired
satellite radio service (see page 78).
Remote control
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
Receiver
To ground
Ground (earth)
wire (not supplied)
wire (not supplied)
Outdoor FM antenna (aerial)