Sony STR-DH710 用户手册

 

Select “SAVE.EXIT” in step 2.
“COMPLETE” appears on the display 
and the settings are registered as selected 
position number.

Press 

V/v repeatedly to select calibration 

type, then press 

.

If you have reposition your speaker, we recommend 
that you perform Auto Calibration again to enjoy the 
surround sound.

The size of a speaker (LARGE/SMALL) is 
determined by the low frequency characteristics.
The measurement results may vary, depending on 
the position of the optimizer microphone and 
speakers, and the shape of the room. It is 
recommended that you follow the measurement 
results. However, you can change those settings in 
the SPEAKER menu (page 77). Save the 
measurement results first, then try to change the 
settings if you want.

Check the problem of the error.

*

xxx 

represent a speaker channel 

F

Front

S

Surround

SB

Surround back

FH

Front high

Perform Auto Calibration again.
 Press 

. “RETRY Y” will appears on the 

display, then press 

.

Repeat steps in “3: Confirming/saving 
the measurement results” (page 36).

FULL.FLAT
Makes the measurement of frequency from 
each speaker flat.

ENGINEER
Sets the frequency characteristics to a set that 
matches that of the Sony listening room 
standard.

FRONT.REF
Adjusts the characteristics of all speakers to 
match the characteristics of the front speaker.

OFF
Sets the Auto Calibration equalizer level to 
off.

xxx

* 31

SPEAKERS is set to “SPK OFF”. Set it to others 
(page 33) and perform the measurement again.

xxx

* 32

None of the speakers were detected. Make sure 
that the optimizer microphone is connected 
properly and perform the measurement again. If 
the optimizer microphone is connected properly 
but the error code appears, the optimizer 
microphone cable may be damaged or 
improperly connected.

xxx

* 33

• None of the front speakers are connected or 

only one front speaker is connected. 

• The optimizer microphone is not connected.
• Either the left or right surround speakers is not 

connected.

• Surround back speakers or front high speakers 

are connected even though surround speakers 
are not connected. Connect the surround 
speaker(s) to the SPEAKERS SURROUND 
terminals.

 

The surround back speaker is connected only 
to the SPEAKERS SURROUND BACK/
FRONT HIGH/BI-AMP/FRONT B R 
terminals. When you connect only one 
surround back speaker, connect it to the 
SPEAKERS SURROUND BACK/FRONT 
HIGH/BI-AMP/FRONT B L terminals.

• Either the front left high or front right high 

speaker is not connected.