Sony TCD-D100 用户手册

Recording

23

Use and connect the optical cable or coaxial cable
according to the digital output jack of the
connected equipment.

Set the INPUT SELECT switch of the connecting
cable to DIGITAL.

Press the 

r REC and P PAUSE buttons.

Press either the ( PLAY or P PAUSE button to
begin recording. Then, begin playback of the
connected source.

Source and sampling frequency for recording
When recording with digital connection, the sources
will be automatically recorded in its own sampling
frequency shown below.

Broadcasting satellite B mode

48 kHz

audio
DAT SP mode

CD

44.1 kHz

MD
DAT SP  mode

Broadcasting satellite A mode

32 kHz

audio
DAT LP mode

Notes
• If “

 

”

is displayed, the source
cannot be recorded.
(See page 38)

• Use only the

recommended digital
cable (not supplied).
(see page 47)
You cannot use the
POC-DA12/DA12M/
DA12S or RK-DA10
digital connecting
cables with this unit.

• Make sure to set the

INPUT SELECT switch
of the connecting cable
to DIGITAL before
recording. Switching it
during recording will
cause a short mute in
the recording.

Tips
In digital connection, note
the following:
• Setting the recording

mode is not required.

• The recording level is

set automatically to the
level of the source.
Manual adjustment is
not available in this
case.

• Setting of the SP•LP

switch is applicable
when recording a 32
kHz source only.
(When set to SP, the
source is recorded in
the 32 kHz SP mode.
When set to LP, the
source is recorded in
the 32 kHz LP mode.)
Other sources will be
automatically recorded
in its own sampling
frequency regardless of
the SP•LP switch. In
this case, you cannot
record in the LP mode.