Sony wega klv s23a10 用户手册
Connecting the TV
19
Conn
ectin
g the
TV
Satellite Receiver
and Cable/Antenna
and Cable/Antenna
This scenario shows a SAT Box connected through the video inputs and the
Cable/Antenna connected through the VHF/UHF input. Satellite signals are
selected by the SAT Box through the video inputs while TV signal is
selected by the TV tuner.
Cable/Antenna connected through the VHF/UHF input. Satellite signals are
selected by the SAT Box through the video inputs while TV signal is
selected by the TV tuner.
To connect a satellite receiver
1
Connect the satellite antenna cable to the satellite receiver’s satellite
input jack.
input jack.
2
Use an A/V and S VIDEO cables to connect the satellite receiver’s
AUDIO and S VIDEO output jacks to the TV’s AUDIO and S VIDEO
input jacks (VIDEO 1 or 3).
AUDIO and S VIDEO output jacks to the TV’s AUDIO and S VIDEO
input jacks (VIDEO 1 or 3).
3
Connect the supplied 75-ohm coaxial cable from the antenna to the
TV’s VHF/UHF input jack.
TV’s VHF/UHF input jack.
4
Run the Initial Setup program, as described in “Setting Up the Channel
List” on page 30.
List” on page 30.
Notes on Using This Connection
If your satellite receiver is not equipped with S VIDEO, use a
VIDEO cable (yellow) instead of the S VIDEO cable.
VIDEO cable (yellow) instead of the S VIDEO cable.
z
VHF/UHF
L
R
4
AUDIO
OUT
PC
AUDIO
IN
S VIDEO
VIDEO
AUDIO
(MONO)
L
R
VIDEO IN
1
3
Y
P
B
P
R
AUDIO
L
R
HD/DVD IN
(1080i/720p/480p/480i)
4
Rear of TV
A/V cable
Satellite Receiver
75-ohm coaxial
cable
cable
Satellite
antenna
cable
antenna
cable
S VIDEO cable
S VIDEO
VIDEO
(yellow)
(yellow)
AUDIO-L
(white)
AUDIO-R
(red)
(white)
AUDIO-R
(red)
To Do This ...
Do This ...
Watch the satellite receiver
Press
WEGA GATE
to select the Satellite input (Video 1, 2 or 3) in
the External Inputs list.
or
Press
TV/VIDEO
repeatedly to select the satellite receiver input
(Video 1, 2 or 3).
Set up the remote control to operate the satellite
receiver
receiver
You must program the remote control. See “Programming the
Remote Control” on page 34.
Remote Control” on page 34.
Activate the remote control to operate the
satellite receiver
satellite receiver
Press
SAT/CABLE (FUNCTION)
.
Control satellite receiver functions with the
remote control
remote control
See “Operating a Satellite Receiver” on page 36.
Label video inputs to easily identify equipment
connected to the TV
connected to the TV
See the instructions for setting up
Label Video Inputs