Panasonic CF-74CCBAXBM 用户手册
17
Get
ting St
arted
U
seful In
formati
on
Troubleshooting
Appendix
6
Press
F10
.
At the confirmation message, select [Yes] and press Enter.
The computer restarts.
z
The computer restarts.
z
If [Enter Password] is displayed during the following procedures, input the Supervisor Password or the User
Password.
Password.
7
Press
3
to execute [3. [Backup]].
At the confirmation message, press Y.
CAUTION
z
When you divide the hard disk into partitions:
Do not execute [1. [Recovery]] to divide the hard disk into partitions. The hard disk backup function cannot be
enabled after the hard disk has been partitioned. Use step 8 to divide the hard disk.
Do not execute [1. [Recovery]] to divide the hard disk into partitions. The hard disk backup function cannot be
enabled after the hard disk has been partitioned. Use step 8 to divide the hard disk.
8
Select the setting.
z
To create a backup area and enable the backup function without dividing the hard disk
Select [1].
Select [1].
z
To create a backup area and divide hard disk into two partitions, for OS and data
Select [2]. Enter the size of operating system partition and press Enter.
• To cancel: press 0.
Select [2]. Enter the size of operating system partition and press Enter.
• To cancel: press 0.
(The size of data partition will be determined by subtracting the operating system partition size from the
maximum size.)
maximum size.)
9
At the confirmation message, press
Y
.
The backup area is then created.
10
When the message [You must reboot in order to enable the Backup function.] appears,
remove the Product Recovery DVD-ROM, and press any key to restart the computer.
remove the Product Recovery DVD-ROM, and press any key to restart the computer.
The computer restarts, then the backup process will begin.
11
When the message [[Backup] is complete] appears, press
Ctrl
+
Alt
+
Del
to restart the
computer.
z
Do not press Ctrl + Alt + Del before the message is displayed.
z
After logging on to Windows, a message will appear indicating that a new device has been installed and that
the computer must be restarted to enable the settings.
the computer must be restarted to enable the settings.
12
Select [Yes] to restart the computer.
NOTE
z
The [Boot] menu in the Setup Utility is now set to start up from the CD/DVD drive. Change it if necessary.
z
To perform the backup/restore function next time; “Creating/Restoring the Backup Data” (Î below).
z
The backup area cannot be accessed from windows.
CAUTION
z
Before executing the backup function, execute a disk error check.
z
Do not interrupt the backup or restore functions. Do not turn off the power and do not press Ctrl + Alt + Del, otherwise
Windows cannot start up, or the data may be lost and the backup and restore functions may not be completed.
Windows cannot start up, or the data may be lost and the backup and restore functions may not be completed.
1
Turn on the computer, and press
F2
several times while [Panasonic] boot screen is dis-
played.
The Setup Utility starts up.
z
z
If the password is requested, enter the Supervisor Password or the User Password.
2
Select the [Exit] menu and select [Hard Disk Backup / Restore], and then press
Enter
.
At the confirmation message, select [Yes] and press Enter.
Creating/Restoring the Backup Data