Panasonic cf-45rjxxxxx 用户手册
16
Using PC Cards
PC Card Utility Program
1
Set [Sound Controller] to [Automatic (PnP)] in the Setup Utility.
2
Select [Start] - [Run].
3
Type "c:\util\drivers\pccard\setup.exe", press [OK], then follow the on-screen instructions.
About PhoenixCard Manager
TM
for Windows
®
95
CAUTION
Follow the installation procedure below only if you will be using the ZV card. Otherwise,
do not perform the installation; abnormal operation may result.
If the hard disk has been reimaged, reinstall PhoenixCard Manager
do not perform the installation; abnormal operation may result.
If the hard disk has been reimaged, reinstall PhoenixCard Manager
TM
for Windows
®
95
if you will be using the ZV card.
NOTE
When running the power conservation function with the sound chip set, there may
be no sound output. In this case, the following setting needs to be made.
In [Control Panel] - [Power] - [OPL3-SAx power management], set [Non Power Save
mode] then press [Apply]. Then press [OK].
be no sound output. In this case, the following setting needs to be made.
In [Control Panel] - [Power] - [OPL3-SAx power management], set [Non Power Save
mode] then press [Apply]. Then press [OK].
CAUTION
After PhoenixCard Manager
TM
for Windows
®
95 has been installed, make sure to power
off the computer before installing or removing the card. Also, do not use the suspend or
hibernation functions if the card is installed.
hibernation functions if the card is installed.
Installing
(only if you will be using the ZV card)
Uninstalling
If you will not be using the ZV card, uninstall PhoenixCard Manager
TM
for Windows 95 in
[Start] - [Settings] - [Control Panel] - [Add/Remove Programs] and follow the procedure
below after restarting the computer.
below after restarting the computer.
1
Select [PC Card (PCMCIA)] in [Start] - [Settings] - [Control Panel].
2
Press [Next] at the display for the [Display Driver Wizard for PC Cards (PCMCIA)],
press [Next] again and then press [Finish]. When the message appears asking whether
to reboot the computer, select [Yes].
press [Next] again and then press [Finish]. When the message appears asking whether
to reboot the computer, select [Yes].