Panasonic dmr-e51 用户手册

ªTo check the remaining time and the current mode 

(28) several times.

(1) Available recording time and recording mode

(e.g.: “0:50 XP” indicates 50 minutes in XP mode)

Notes
≥The message “Cannot record. Maximum number of 

programmes recorded.” is displayed if you try to start recording 
when there are already 99 programmes on a disc. Erase 
unneeded programmes (DVD-RAM/DVD-R) or use a new disc to 
continue recording.

≥Check that disc can be recorded on (page 8).

For your reference
≥You can record up to 99 programmes on one disc.
≥You cannot change the channel or recording mode during 

recording. You can change them while recording is paused, but 
the material is recorded as a separate programme.

≥An error message appears if you try to start recording when a 

disc is full; the remaining time will be shown as “0:00”. To 
continue recording, erase unneeded programmes (DVD-RAM 
only (page 34), Erasing programmes) or use another disc.

≥There are limitations when recording to DVD-R (page 9).≥The message “Can not record on the disc.” is displayed when 

recording was not completed correctly. Check the discs for dirt or 
scratches.

≥Recording cannot be performed correctly if you try to record PAL 

system to a disc that already contains recordings using NTSC.

[RAM] [DVD-R]

The unit calculates a recording rate that enables the recording to fit 
in the time you set (within the remaining time on the disc) and with 
the best possible picture quality.

(26).

3, 4, 2, 1] (10) to set the recording time.

3, 4, 2, 1] (10) to select “Start” and press 

(10).

≥Recording starts.

For your reference
≥Press [STATUS] (28) during recording to show the remaining 

time.

≥It is not possible to change channel or recording mode while 

flexible recording is paused.

≥Recording time reduces if you repeatedly pause recording.

[RAM] [DVD-R]

This is a simple way of making timer recordings when you are in a 
hurry or before you go to bed. You can set the time up to 4 hours in 
advance.

¥, REC] (16) on the main unit to select the 

The time increases as illustrated each time you press the button.
The counter decreases in 1-minute units after you set a time. You 
can change the time again with the same operation.
When the time you set is reached, recording stops and the unit 
switches to standby.

Unit’s Display
(Counter) 

# 30 # 60 # 90

^ 240 ! 180 ! 120 !}

(2) Shows recording will stop in 30 minutes

ªTo cancel

During recording, press [

¥, REC] (16) until the counter appears.

≥Recording continues.

ªTo show the time remaining until recording finishes
Press [STATUS] 

(28) several times.

For your reference
≥This does not work during timer recordings or while using flexible 

recording.

≥You cannot use the remote control to specify a time for recording 

to stop.

≥Recording stops and the set time is cleared if you press [∫] (7).≥The set time is cleared if you change the recording mode or 

channel while recording is paused.

π

 Remain           0:50  XP

0:07:21  6.8.

π

 PRG2  0:05.14  XP

π

 PRG1  0:00.10  SP

REC

PLAY

DVD-RAM

(1)

LR

REC  83

ARD

DVD-RAM

LR

(2)

REC/OTR  30

ARD

DVD-RAM

LR

DVD(PAL).book  20 ページ  ２００３年５月２２日　木曜日　午後１２時３分