Panasonic dvd-pv55 用户手册

下载
页码 46
43
VQT8645
For Your Reference
Troubleshooting Guide
Before requesting service for this unit, check the chart below for a possible cause of the problem you
are experiencing. Some simple checks or a minor adjustment on your part may eliminate the problem
and restore proper operation.
If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve
the problem, consult your dealer for instructions.
Problem
No power.
Unit turns off
automatically.
Cannot charge battery
pack or the [CHG]
indicator fails to light.
Unit doesn’t work when
powered by the battery
pack.
Play fails to start or stops
soon after starting.
No response when
buttons are pressed.
No operation with remote
control.
Page
12–13
19
13
19
19
13
12
10
11
18
31
10, 19
19
12
12
12
Solution
Check connections to the AC adaptor or battery pack.
Release the hold mode.
Confirm the battery charge on the unit’s display.
You cannot turn on the unit with the remote control if the unit
is powered by the battery pack.
The unit turns off after it has been stopped for about 
15 minutes (5 minutes when using the battery pack) to
conserve power. Turn the unit on again.
Charging is only possible in standby mode.
The charging time increases if the battery pack is warm and
charging may not be possible under some circumstances.
Wait for the battery pack to cool off.
Check connection to the AC adaptor.
The battery pack has protection circuitry that activates if the
pack becomes too hot or too cold. The battery pack will not
work if this occurs. Use the unit at about 20 
o
C.
Condensation may have formed in the unit. Wait an hour for
it to clear.
This unit cannot play discs other than those specified.
Wipe the disc clean.
Ensure the disc is inserted correctly.
Check the ratings setting.
Some discs prohibit certain operations.
Release the hold mode.
If there is no response at all, the unit may have been
affected by lightning or static electricity. Try turning the unit
off and on again. Alternatively, turn the unit off, disconnect
the power source (AC or battery pack) reconnect the power
and turn the unit on again.
Check that the battery is inserted correctly.
Replace the battery if it is drained.
Aim the remote control at the remote control signal sensor.