Panasonic kx-tcd340 用户手册
Useful Information
69
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
The handset/base unit stops
working while being used.
working while being used.
L
Disconnect the AC adaptor and turn off the
handset. Connect the AC adaptor, turn on the
handset and try again.
handset. Connect the AC adaptor, turn on the
handset and try again.
While storing an entry in the
phonebook or assigning a one
touch dial, the handset starts to
ring.
phonebook or assigning a one
touch dial, the handset starts to
ring.
L
A call is being received. To answer the call, press
{C}
{C}
. Programming will be cancelled. Start again.
Pressing q/ {R} does not
display/dial the last number dialled.
display/dial the last number dialled.
L
The redialled number was more than 24 digits long.
Redial the number manually.
Redial the number manually.
The handset beeps intermittently
and/or 3 flashes.
and/or 3 flashes.
L
Fully charge the batteries (page 13).
I fully charged the batteries, but
3
3
still flashes.
L
Clean the charge contact and charge again (page
13).
13).
L
It is time to replace the batteries (page 15).
Caller information is not displayed. L You must subscribe to Caller ID service.
L
Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
While viewing caller information,
the display returns to standby
mode.
the display returns to standby
mode.
L
Do not pause for over 1 minute while searching.
I cannot set call restriction.
L
Call restriction can be set using handset 1 only. If
you have multiple handsets, you can confirm which
handset is handset 1 by pressing {x} and {1} on
the base unit. Handset 1 will start ringing.
you have multiple handsets, you can confirm which
handset is handset 1 by pressing {x} and {1} on
the base unit. Handset 1 will start ringing.
I cannot register a handset to a
base unit.
base unit.
L
The maximum number of base units (4) are already
registered to the handset. Cancel unused base unit
registrations from the handset (page 59).
registered to the handset. Cancel unused base unit
registrations from the handset (page 59).
L
The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 59).
registered to the base unit. Cancel unused handset
registrations from the base unit (page 59).
L
You entered the wrong PIN number. If you forget
your PIN, consult your nearest Panasonic service
centre.
your PIN, consult your nearest Panasonic service
centre.
L
Locate the handset and the base unit away from
other electrical appliances.
other electrical appliances.
Problem
Cause & solution
TCD340E(e).book Page 69 Thursday, June 9, 2005 9:50 AM