Panasonic SC-HT1500 安装指南
2
STEP
1
Front and surround speaker assembly
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥For assembly, use a Phillips-head screwdriver.
≥For assembly, use a Phillips-head screwdriver.
1
Attach the pipe to the large base.
1 Thread the speaker cable through the base.
≥For quicker threading, fold the cable lightly in half (do not crease), pass the
≥For quicker threading, fold the cable lightly in half (do not crease), pass the
folded portion through the hole in the base, and then pull through the rest
of the cable.
of the cable.
2 Insert the pipe.
3 Secure the pipe to the base.
Ensure the screw is securely fastened.
2
Attach the stands to the front and surround speakers.
≥There is no difference between the right and left speakers and stands.
≥Using the polyfoam and packaging cover included with this unit may ease attachment.
≥Using the polyfoam and packaging cover included with this unit may ease attachment.
1 Remove the mounting plate screw, and remove plate B.
2 Place the pipe on plate A and attach plate B.
Rotate the pipe so that the flat side is facing away from the back of the
speaker.
speaker.
3 Secure the plate with the same screw removed in procedure 1.
Make sure you have all the
indicated components before
assembly, setup, and connection.
indicated components before
assembly, setup, and connection.
∏ Front speaker units ∏ Surround speaker units ∏ Pipes
∏ Large bases
∏ Washer screws
Groove
Cable
Hole for screw
Thread the speaker cable
through here.
through here.
1
2
Lessen excess
speaker cable.
speaker cable.
Insert the pipe while slightly pulling on the speaker cable.
The supplied stands are specially designed for attachment to
Panasonic SB-FS1501 front speakers and SB-PS1501 surround
speakers. Only use as indicated in this setup.
Panasonic SB-FS1501 front speakers and SB-PS1501 surround
speakers. Only use as indicated in this setup.
Cable
Rear side of base
Washer screw
2
1
3
Mounting plate screw
Speaker
Polyfoam
Packaging cover
Plate B
Plate B
Plate A
[Note[
The stands with longer
cables are for the
surround speakers.
cables are for the
surround speakers.
Fit the offset into the slot and slide
plate B into the locked position.
plate B into the locked position.
Offset
Slot
Plate B
Align the surface of plate B so that it
is even with the pipe surface.
is even with the pipe surface.
Plate B
Pipe
Plate A
Plate A
Supplied Accessories