Panasonic tx-32lx600p 用户手册
F
AQs, etc.
•
Frequently Asked
Questions
37
Problem
Actions
Screen
Sound
HDMI
Chaotic image, noisy
•
Set "P-NR" in the Picture menu (to remove noise).
(p. 16)
(p. 16)
•
Check nearby electrical products
(car, motorcycle, fl uorescent lamp).
(car, motorcycle, fl uorescent lamp).
No image can be
displayed
displayed
•
Is "Colour" or "Contrast" in the Picture menu set to the
minimum? (p. 16)
minimum? (p. 16)
Blurry or
distorted image
distorted image
(no sound or low volume)
•
Reset channels. (p. 20)
Neither image nor
sound is produced
sound is produced
•
Is the TV in "AV mode"?
•
Is the mains lead plugged into the socket outlet?
•
Is the TV turned On?
•
Check Picture menu (p. 16) and volume.
No sound is produced
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
Sound is unusual
•
Set the sound setting of the connected equipment
to "2ch L.PCM".
to "2ch L.PCM".
•
Check the "HDMI1 input" setting in the Sound menu. (p. 16)
•
If digital sound connection has a problem, select analogue
sound connection. (p. 33)
sound connection. (p. 33)
Sound level is low
or sound is distorted
or sound is distorted
•
Sound signal reception may be deteriorated.
•
Set "MPX" (p. 16) in the Sound menu to "Mono".
An error message
appears
appears
•
Follow the message's instructions.
•
If the problem persists, contact the authorized Service Centre.
An error message appears
•
Contact the authorized Service Centre.
“Control with HDMI”
function does not work
function does not work
•
Switch the TV on again with the equipment on.
•
Set “Control with HDMI” to “Off”, then set to “On” again.
(p. 27)
(p. 27)
The SD card cannot be
used even when it is
formatted
used even when it is
formatted
•
Contact the authorized Service Centre.
Other
SD
TV goes into
"Standby mode"
"Standby mode"
•
The sleep function is activated.
•
The TV enters "Standby mode" about 30 min. after
broadcasting ends.
broadcasting ends.