Panasonic WJ-GXE900 用户手册

13

q Power Indicator (OPERATE)

This indicator lights up when the power of the
decoder is on.
When the temperature inside the decoder becomes
remarkably high, this indicator will start blinking.

It will take around 2 minutes to start up the decoder
after turning the power on.
During start up, the STATUS indicators (STATUS 1 -
5) will light up in order. When the STATUS 5
indicator lights up, it is possible to operate the
decoder.
Each STATUS indicator will light, blink or go off
according to the status of this decoder.

w Network Status Indicators (LINK1, 100, 1000,

ACT)
LINK1 Indicator: This indicator lights up when the

connection with the network is established. 

100 Indicator: This indicator lights up during the

100BASE-TX connection.

1000 Indicator: This indicator lights up during the

1000BASE-T connection.

ACT Indicator: This indicator lights up when the

decoder is receiving or sending packets.

e Status Indicators (STATUS 1 - 4)

STATUS 1 - 4: These indicators display the status of

VIDEO OUT 1 - 4.
Each of the STATUS 1 - 4 indicators displays the
status of the VIDEO OUT 1 - 4 connectors
respectively. The respective STATUS indicator

OPERATE

1

ACT

1000

100

LINK1

STATUS

2

3

4

5

6

7

8

OPERATE

q

w

e

r

t y

u

!0 Audio Input Connector (AUDIO IN 1 - 4)

(–10 dB, 9-pin D-sub)
Up to 4 audio devices can be connected. To connect
audio devices, a cable (WV-CA64, not supplied) is
required.

!1 Signal Ground Terminal (SIGNAL GND)

!2 Power Cord

Connect to an AC outlet (120V AC, 60 Hz).