FIC a440 服务手册
Installation and Upgrade
FIC A440 Series Service Manual
2-3
2.2.2 Installing the DVD-ROM or CD-ROM Driver (For DOS)
This section provides installation guide for the DVD-ROM or CD-ROM device driver under
MS-DOS and other operating systems.
MS-DOS and other operating systems.
For DOS installation, you must have a pre-installed MS-DOS v6.0 or higher
operating system on your hard disk with the “MSCDEX.EXE“ (Microsoft CD
Extension) driver file. For DOS, this is located under the DOS directory. For
Windows 95/98, this is located under the \WINDOWS\COMMAND subdirectory.
operating system on your hard disk with the “MSCDEX.EXE“ (Microsoft CD
Extension) driver file. For DOS, this is located under the DOS directory. For
Windows 95/98, this is located under the \WINDOWS\COMMAND subdirectory.
Installing the CD-ROM driver under DOS prompt
1. Boot up the system of your computer and insert the Teac CD-ROM driver diskette into
the floppy drive.
2. Change the directory of the DOS prompt to Drive A and run the CD-ROM installation
program by typing the command A:\>INSTALL.
3. The CD-ROM Setup program will appear and ask you for directory name where the
driver will be installed. Press <Enter> to install into the default directory.
4. With "Auto Select" selected, press <Enter> to continue with the installation.
5. With "Modify the file now" selected, press <Enter> to modify AUTOEXEC.BAT file.
6. With "Modify the file now" selected, press <Enter> once again to modify CONFIG.SYS
file.
7. Finally, press <Enter> to complete installation. Then, restart the computer after
installation is complete. Your computer will then detect the CD-ROM drive and will
display the designated drive letter. The CD-ROM drive should be assigned to Drive D. If
you have two disk partition, the CD-ROM drive will be assigned to Drive E.
display the designated drive letter. The CD-ROM drive should be assigned to Drive D. If
you have two disk partition, the CD-ROM drive will be assigned to Drive E.
Installing the DVD-ROM driver under DOS prompt
1. Boot up the system of your computer and insert the Toshiba DVD-ROM driver diskette
into the floppy drive.
2. Change the directory of the DOS prompt to Drive A and run the DVD-ROM installation
program by typing the command A:\>INSTALL.
3. The DVD-ROM Setup program will appear and ask you to press <Enter> to start
installation or press <ESC> key to exit installation program.
4. A connection diagram appears with a message shown "Confirm the connection
environment of the computer, Are you sure?" Press <Y> to confirm.
5. The installation program will ask you to specify the directory where you want to place the
DVD-ROM driver. Press <Enter> to install into the default directory.
6. Press <Enter> to continue with the next step.