FIC a440 服务手册

 

Installation and Upgrade 

 

2-8 

FIC A440 Series Service Manual 

1.  Make sure the system is powered off and that no peripheral devices are attached. Turn the 

system over and locate the screw on the internal modem / LAN door. 

 
2.  Remove the screw and open the internal modem / LAN door. Locate the alignment notch 

on the modem module. 

 
3.  Locate the modem module socket. Align the notch with the notch in the socket connector 

and insert the module as follows: 

−  Insert the cable into the modem module. 

−  Hold the modem module at an angle and align the modem module connector with 

the socket in the system. Push the connector into the socket. 

−  Press down on the edge of the modem module until the locking tabs on the sides 

snap into place, securing the module. 

 

 

 

4.  To remove the modem module, press the locking tabs away from the sides of the module 

until the module pops up. Then, remove the modem module. 

 
5.  Reassemble the notebook components as follows: 

−  Put the internal modem / LAN door back. 

−  Replace the screw. 

−  Turn the system over. 

 
6.  Boot Windows 98 from your hard disk and insert the driver CD containing the modem 

driver. 

 
7. Click 

the 

Start button, and then click Run. In the Run dialog box, click Browse button 

and navigate into the directory where the modem driver is. Then, run “Setup.exe”. 

 
8.  The Welcome message box appears. Click Next to begin installing modem driver. 
 
9. With 

“Yes, I want to restart my computer now” selected, click Finish to complete the 

modem installation. 

 
Installing Internal Modem for Windows 2000 
1.  After the internal modem module is carefully inserted into the socket, boot to Windows 

2000 and insert driver CD containing internal modem driver for Windows 2000.