JVC LVT1236-004A 用户手册

7

Before connecting:
• Make sure to match the polarity (

ª and ·) when connecting the speaker cords.

• Turn off the power to the amplifier before connecting the speaker system; otherwise,

the speakers may be damaged.

• The impedance of the speaker is 6 

Ω.

If this does not match with the speaker impedance range indicated on the amplifier,
you cannot connect this system to the amplifier.

• The maximum power handling capacity of the SX-WD5 is 100 W. Excessive input will

result in abnormal noise and possible damage.

Daily operations and maintenance:
• Be sure to turn down the volume level on the amplifier to prevent unwanted noise

before performing following operations:
– Turning on or off other components
– Operating the amplifier
– Tuning FM stations
– Fast-forwarding a tape
– Continuously reproducing high frequency oscillation or high pitch electronic sounds
– Connecting or disconnecting a microphone

• When using a microphone, do not aim it at the speakers or use it near the speakers;

otherwise, the howling which occurs may damage the speakers.

• Before replacing the cartridge, always turn off the power both to the amplifier and to

the turntable; otherwise, the clicking noise may damage the speakers.

7

• Twist and remove the insulation at the end of each speaker cord before

connecting.

1

2

3

To the speaker 

ª

terminal of amplifier

To the speaker 

·

terminal of amplifier

Silver

ª terminal
(Red hoop)

· terminal

(Black hoop)

Copper

EN_SX-WD5[J].p65

11/04/2005, 12:42 PM

3