LG d5966g 用户手册

O P T I O N A L   AC C E S S O R I E S

O P T I O N A L   AC C E S S O R I E S

Install 2 screws to securely attach the bracket 
to the pedestal.

Once properly attached, firmly press the top 
part of the bracket with the double-sided 
tape to the side of the appliance. Repeat 
steps 2–4 to attach the other brackets.

NOTE: If the brackets are not installed 
properly, noise and vibration may result. Be 
sure to remove paper backing and to use all 
screws to install the brackets.

Move the appliance to the desired location.

Make sure the side surface of the appliance 
is clean and dry. Remove paper backing from 
the tape on the bracket.

Position the bracket as shown. The bent part 
of the bracket should rest along the edge 
of the pedestal, and the holes in the bottom 
part of the bracket should align with the 
holes in the pedestal.

Loosen the locknuts on all 4 leveling feet 
of the pedestal until you can turn them 
with the wrench. Turn clockwise to raise 
or counterclockwise to lower. Once the 
pedestal is level and all 4 feet are solidly 
against the floor, securely tighten all locknuts 
by hand.

NOTE: Noise and vibration may result if 
locknuts are not tightened. 

Be sure to connect the appliances to all 
water, power, or gas lines and draining or 
venting connections before operation. 

If there is excessive vibration during the 
first operation after installation, slightly 
adjust the leveling feet.

Raise

Lower

34