Yamaha RX-V1600 用户手册
109
TROUBLESHOOTING
ADDITIONA
L
INF
O
RMA
T
IO
N
N
English
After AUTO SETUP
• If the ERROR or WARNING screens appears, check the cause of the problem, then perform the AUTO SETUP procedure again.
• If warning W-1 appears, corrections are made, but they may not be optimal.
• If warning W-2 or W-3 appears, no corrections are made.
• If error E-10 occurs repeatedly, please contact a qualified YAMAHA service center.
• If warning W-1 appears, corrections are made, but they may not be optimal.
• If warning W-2 or W-3 appears, no corrections are made.
• If error E-10 occurs repeatedly, please contact a qualified YAMAHA service center.
■ HDMI
Warning message
Cause
Remedy
See
page
W-1:OUT OF PHASE
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
message may appear depending on the
speakers even when the speakers are
connected correctly.
Check the speaker connections for proper polarity
(+ or –).
(+ or –).
15
W-2:OVER 24m (80ft)
The distance between the speaker and the
listening position is over 24 m.
listening position is over 24 m.
Bring the speaker closer to the listening position.
—
W-3:LEVEL ERROR
The difference of volume level among
speakers is excessive. (No level correction
is made.)
speakers is excessive. (No level correction
is made.)
Readjust the speaker installation so that all speakers
are set in locations with similar conditions.
are set in locations with similar conditions.
—
Check the speaker connections.
15
Use speakers of similar quality.
—
Adjust the output volume of the subwoofer.
33
Notes
Error message
Cause
Remedy
See
page
DEVICE OVER
More than 5 HDMI components including
this unit are connected.
this unit are connected.
Reduce the number of the connected HDMI
components.
components.
—
HDCP ERROR
HDCP testing failed.
Check that the connected HDMI components support
the HDCP copy protection standards.
the HDCP copy protection standards.
—