Crestron qs sw-dat c2n-dap8 rc 用户手册

Digital Audio Tools 

Crestron DAT Software 

This menu includes Restore Factory Default Settings, which will return the unit to its original “out-of-the-
box” configuration. Default settings are noted throughout this document. 

This is standard for all software applications and allows the choice to display the tool bar.  

This menu allows the choice of how many equalizers to display in the Parametric EQ tab. There is a single 
EQ view and a view with two EQs. 

This menu allows you to enter Realtime Mode (

 

on the tool bar). Realtime Mode lets you hear all of the 

configuration changes immediately as they are made, unless otherwise specified. Once in Realtime Mode, you 
can choose Source/Noise Steering (

 on the tool bar). Selecting the Source/Noise Steering mode allows you 

to select the built-in Pink Noise or Dolby Noise noise generators. You can also select an external noise source 
or other program material for aid in setup of the DAP8/RC. In the “Source/Noise Steering” window, you can 
specify speakers as active or inactive, thus allowing the adjustment of each speaker independently. 

NOTE: When using any Source/Noise Steering selection, Bass Management is not active. 

This menu allows you to navigate through the tabs. 

This is an emergency mute button that will immediately mute the DAP8/RC and all of its outputs. Pressing 
the button again does not turn mute off. To un- mute the DAP8/RC, you must click the mute icon 

 on the 

tool bar or select Tools | Mute or press F8. (First, make sure the sound level is back to a reasonable level.) 

Use these buttons to navigate back and forward through the tabs, one at a time. 

The Communications tab allows you to define the settings for communication with the C2N-DAP8/RC in 
order to download existing configuration files and upload new ones. It is important that you set the 
communication parameters first before doing any of the other setup procedures. 
The Connection Settings area is where you set the parameters for communication with the C2N-DAP8/RC. 

Pass To: Checking this box means that the unit being configured is a Cresnet device and will 
have its configuration sent to it through a Crestron control processor. If this box is unchecked, 
then communication with the device is directly through its own RS-232 port. Refer to the 
DAP8/RC manual for assistance with this communication type. 

• Digital Audio Processors: C2N-DAP8/RC