Aleratec 330107 用户手册

www.aleratec.com

16

Asynchronous Copy+Compare is used only when the source content 

is the same as or less than the system buffer (256MB). With the source 

content read into the systems buffer you can copy and compare flash drives 

continuously by taking out the drive which has finished its Copy+Repair 

cycle, and replacing it with another blank. This process is repeated until the 

Copy+Compare job is complete.    

1.  Load the source flash drive into the USB Duplicator. Use the UP or 

DOWN arrow to scroll through the menu until Copy+Compare is 

displayed on the LCD screen.  

2.  Press the OK button on the display panel. The USB Duplicator will 

start to read the source content into the system’s buffer and immediately 

start copying any loaded target USB flash drives.

3.  Load the blank target flash drives into the USB Duplicator. The LCD 

will display the number of blank media loaded and copying.

Note: When copying is in process the Green LED on the front panel is 
blinking. Do not take out the drive while it is copying. When copying is 
finished the Green LED stays on (no blinking). If an error occurs during 
the copy process a Red LED will display. 























