Troy-Bilt Bronco 用户手册
Maintenance & Adjustments
6
15
WARNING!
Before inspecting, cleaning or servicing
the machine, shut off the engine, wait for all moving
parts to come to a complete stop, disconnect the
spark plug wire and move the wire away from the
spark plug. Failure to follow these instructions can
result in serious personal injury or property damage.
Maintenance
Engine
Refer to the Engine Operator’s Manual packed with your tiller for
all engine maintenance.
Tire Pressure
Check the air pressure in both tires. The air pressure should be
between 15-20 PSI. Keep both tires equally inflated to help
prevent machine from pulling to one side.
Hardware
Check for loose or missing hardware after every 10 operating
hours and tighten or replace (as needed) before using tiller
Be sure to check the screws underneath the tiller hood that
Be sure to check the screws underneath the tiller hood that
secure the transmission cover and the Depth Regulator Lever to
the transmission.
Lubrication
After every 10 operating hours, oil or grease the lubrication
points shown in Fig. 6-1 and described below.
Wheel Shaft
Tine Shaft
Handlebar
Attaching Screws
Depth
Regulator
Lever
Figure 6-1
Maintenance Schedule
Check After
first 2 hours
Before each
use
Every
5 Hours
Every
10 Hours
Every
30 Hours
See Engine
Manual
Check Motor Oil Level
P
P
Clean Engine
P
P
Check Drive Belt Tension
P
P
Check Nuts and Bolts
P
P
Lubricate Tiller
P
Check Gear Oil Level in Transmission
P
Check Tines for Wear
P
Check Air Pressure in Tires
P