Star Micronics TCP2000 Series 用户手册
7
CONNECTION TO EXTERNAL UNITS AND SETTING
(Housed unit TCP100/2000 series)
<Connecting the interface cable>
1 Turn OFF the power of the host computer and the reader/writer.
2 Plug in an end of the interface cable to the reader/writer connector and
2 Plug in an end of the interface cable to the reader/writer connector and
the other end to the serial port of the host computer.
3 Fasten two screws located at both the shoulders of the interface cable
connectors.
4 Modular connector: Connects to Star original stand-alone terminal
MCD2000 by specified cable.
Please set the interface convert switch to the left side.
Note) Do not connect to any external devices other than MCD2000.
Please set the interface convert switch to the left side.
Note) Do not connect to any external devices other than MCD2000.
[TCP100]
[TCP2000]
<Serial Interface (RS-232C)>
1 Applicable connector :
D-sub 9 pin (female)
2 Mating connector :
D-sub 9 pin (male)
3 Connector terminals :
See the table below
4 I/O circuit :
See the table below
5 Level :
RS232C
6 Cable :
Cross (reverse) cable
Pin No. Signal name
Direction
Function
2
RXD
IN
Received data
3
TXD
OUT
Transmitted data
4
DTR
OUT
Data-terminal-ready (always ON after reset)
5
S-GND
-
Signal ground
6
*
CTS/DSR
IN
Clear-to-send / Data-set-ready (no detection)
7
RTS
OUT
Request-to-send (always ON after reset)
*
CTS is assigned to pin #8 at TCP2000.(no detection)
5