Edelbrock 5292 用户手册

©2007 Edelbrock Corporation
Catalog #5292

Page 2 of 2

Brochure #63-5292

Rev. 9/07 - KS/mc

1.

Disconnect negative battery cable.

2.

Jack up and support vehicle, support vehicle with
jackstands, rated to support vehicle weight on a
level and solid ground. Jackstands must be set so
vehicle’s weight is loaded as if vehicle were being
supported by its wheels. A drive-on style lift or
drive-on stands are preferred.

3.

Unbolt parking brake cable brackets from rear
lower trailing arm sub-frame pocket.

4.

Remove under car wind deflectors.

5.

Remove nut retaining fuel lines just rear of left
side wind deflector.

6.

Slide left side mid frame bracket #23-2156 above
fuel lines, taking care when prying fuel lines down
so not to bend or kink them. Bolt bracket to outer
sill rail using two(2) supplied 10mm bolts washers
and lock washer. There are nut inserts in sill rear.

7.

Unbolt only the left side rear engine - K-member
bolts.

8.

While carefully prying down on K-member, slide
left Edelbrock sub-frame connector #25-4085
between K-member and vehicle floor. Align front
of Edelbrock sub-frame connector bolt holes with
K-member bolt holes. Use supplied 10mm bolt
washer and lock washer to bolt rear of sub-frame
connector up to vehicle’s sub-frame. Mark around
where Edelbrock sub-frame connector is to be
welded to vehicle and mid sub-frame bracket.
Remove Edelbrock sub-frame connector. Clean
off paint and any under coating.

9.

Re-install left sub-frame connector and weld into
vehicle. Protect fuel and brake lines from welding.
Weld sub-frame connector to mid frame bracket.
It may require clamping.

10.

Torque front K-member bolts to 80 ft. lbs. Use
thread lock compound on threads.

11.

Unbolt only right side rear engine K-member bolts.

12.

Bolt mid frame bracket to outer sill rails in the
10mm nut inserts using supplied 10mm bolts
washer and lock washer. The inside sub-frame
bolt location should align with the middle bolt
location that retained the wind deflector, use
original bolt from wind deflector.

13.

While carefully prying down on K-member, slide
right Edelbrock sub-frame connector #25-4086
between K-member and vehicle floor. Align front
of Edelbrock sub-frame connector bolt holes with
K-member bolt holes. Use supplied 10mm bolts
washer and lock washers to bolt rear of sub-frame
connector up to vehicle’s sub-frame. Mark around
where Edelbrock sub-frame connector is to be
welded to vehicle and mid sub-frame bracket.
Remove Edelbrock sub-frame connector from
vehicle, clean paint and any under coating from
where welding is to take place.

14.

Re-install right sub-frame connector and weld into
vehicle. Weld sub-frame connector to mid frame
bracket.

Clamping of pieces to close up gaps

maybe required as weld is done.

15.

Torque front K-member bolts to 80 ft. lbs. using
thread lock compound.

16.

Grind excess weld as needed. Clean and paint to
prevent rust from forming.

17.

Attach parking brake cable brackets to studs on
the inside of Edelbrock sub-frame connectors
using supplied 5/16 nuts and flat washer.

18.

Replace nut on fuel line retainer clip that was
removed in Step 5.

19.

Install under car wind deflectors.

20.

Connect negative battery cable.