EDGE Tech chevy-gmc duramax diesel lb7 用户手册

Edge Products, LLC                                                                    GM LB7 EZ Manual 

 

8

 

Installing the EZ Module 

 

Connectors

1.  The Power Edge LB7 EZ Module can mount on top of or to the side of the 

black plastic fuse box cover located on the driver’s side fender. Adhere the 
module using the supplied Velcro, allowing enough harness movement for 
removal of the cover. 

2.  Disconnect both stock 

connectors by squeezing the 
ears on the backside of the 
connector and pulling the 
gray lever. 

3.  Gently insert the EZ 

connectors and lock in place 
with the gray levers, and then 
gently connect the stock 
connectors to the other end of 
the EZ connectors. 

 
Notice: Use caution when inserting connector bodies. If the connector does not 
slide smoothly, remove the connector, inspect the pins, and retry installation. 
 

4.  Recheck all connections for a properly secure installation.  Using the 

supplied wire ties, secure the wiring harness to prevent possible damage. 

 

5. 

Start the engine. The engine should start and run like a stock truck. If the 
engine does not start or run properly, turn off the motor, remove the keys 
from the ignition, then remove the EZ module and inspect the pins inside 
both connectors. Straighten pins or clear foreign material from the pins 
and connector surfaces, then re-install the connectors.  If failure 
conditions still exist, contact your dealer or Edge Products, LLC.  When 
trying to restart, make sure that the key has been turned off for at least 10 
seconds before cranking the engine

.