TEAC DR-H300 用户手册

下载
页码 136
Connect the loop antenna’s wires to the AM antenna
terminals.
Press the lever, insert the end of the cord,
then release the lever. Make sure it is fastened
securely by pulling the cord lightly. Make sure
only the bare, stripped wire is inserted in the
jack and that no plastic insulation is
preventing contact between the antenna wire
and terminal.
Place the antenna on a shelf or hang it on a window frame,
etc., in the direction which gives the best reception. Keep all
other wires such as power cords, speaker wires or
interconnect wires as far away as possible from the antenna.
6
Connection (AM antenna)
<
If the AM loop antenna provided does not deliver sufficient
reception (often due to being too far from the transmitter or
in a concrete building, etc.), it may be necessary to use an
outdoor AM antenna.
Use either a high quality commercial AM antenna or, if not
available, an insulated wire more than 5 m long, strip one
end, and connect this to the terminal as shown.
The antenna wire should be strung outdoors or indoors near
a window. For better reception, connect the GND terminal to
a reliable ground.
AM Indoor Loop Antenna
The high-performance AM loop antenna provided with this
unit is sufficient for good reception in most areas.
To stand the loop antenna on a surface, fix the claw to the
slot in the antenna base. 
Note:
Even when using an outdoor AM antenna, do not disconnect
the AM loop antenna.
AM loop antenna
outdoor AM
antenna