Toyota 75105 用户手册

INSTALLATION INSTRUCTIONS

Product No.

SMALL PARTS

PACKAGE K75105

WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.

IMPORTANT NOTES

USE ONLY TOWING PRODUCTS SUPPLIED OR APPROVED BOLTS,
LOCKNUTS, AND WASHERS TO INSTALL THIS HITCH

(OVER)

TOYOTA TUNDRA

TOOLS REQUIRED

3/4” SOCKET
18mm SOCKET
TORQUE WRENCH

12mm HEX BOLT

1/2” SERRATED WASHER

1/2” CARRIAGE BOLT

1/2” SERRATED WASHER

BOLT PLATE

1/2” LOCK NUT

1. Lift the receiver up to the frame of the vehicle. Locate the large holes in the receiver brackets over the rivet heads in the

frame.

2. Install four (4) 1/2” serrated washers over four (4) 12mm hex bolts and insert the bolts up through the receiver brackets

and into the weld nuts in the frame. See the diagram above.

3. Install two (2) bolt plates over two (2) 1/2” carriage bolts and insert the bolts down through the frame and the receiver

brackets. Install 1/2” serrated washers and 1/2” lock nuts on the bolts. See the diagram above.

4. Torque the 12mm bolts to 75 LB-FT.

Torque the 1/2” nuts to 75 LB-FT.

TO WELD NUTS IN THE FRAME

PLYMOUTH, MI

33049
75105

For Installation Assistance or Technical Help, Call 1-574-537-6339