Siemens siemens network router mc35 用户手册
Remote-SAT User's Guide
MC35_SAT_01_v02.00
Page 44 of 65
11.01.2002
1.5.2.3 AT^SSTR Remote-SAT Response – Setup Call (16)
Write command
AT^SSTR=16,
<status>
<status>
The TA indicates if the call setup has been accepted by the user.
For further details please refer to chapter “AT^SSTGI Remote-SAT Get
Information – Setup Call (16)”, pg. 26.
For further details please refer to chapter “AT^SSTGI Remote-SAT Get
Information – Setup Call (16)”, pg. 26.
Response
After confirmation phase the TA may show a dialling animation on the screen
until a mandatory response parameter is issued.
until a mandatory response parameter is issued.
^SSTR: <pac>, <TermQualifier>, <TerminationCauseText>
For a detailed explanation of these parameters please refer to chapter
“AT^SSTGI Remote-SAT Get Information – Setup Call (16)”, pg. 26.
“AT^SSTGI Remote-SAT Get Information – Setup Call (16)”, pg. 26.
OK
Parameters
<cmdType> 16 – Proactive command ID, see Table 1.
<status>
Unsigned Integer, range 0-255
0
0
Command performed successfully
Indicate that the user has accepted the call request.
Indicate that the user has accepted the call request.
16
Proactive SIM session terminated by user
20
USSD/SS Transact terminated by user
32
TA currently unable to process command
132
TA currently unable to process command because
screen is busy.
screen is busy.
34
User did not accept the proactive command.
Indicate that the user has denied the call request.
Indicate that the user has denied the call request.
35
User cleared down call before connection or network
release
release
Reference
Siemens
Note