Ariens sno-thro 932103 - 624 用户手册

GB - 21

Over time the rubber edges of the auger will 
wear. Contact your Ariens Dealer for 
replacement.
IMPORTANT: Replace rubber edges before 
metal auger begins to wear.
NOTE: After replacement of auger rubber 
edges, adjust scraper blade. See Scraper 
Blade Adjustment below.

IMPORTANT: Damage to auger/impeller 
housing will result if blade wears down too far.
Scraper blade is adjustable to compensate for 
wear.
To adjust scraper blade:

1. Tip unit back onto handlebar, support 

housing and loosen nuts retaining blade.

2. If unit does not scrape cleanly, move 

scraper blade forward. If unit does not 
drive forward and scraper blade drags, 
move scraper blade to the rear.

Tighten hardware and test unit. Repeat 
adjustment as required until proper operation 
is obtained.

IMPORTANT: NEVER spray unit with high 
pressure water or store unit outdoors.
Run with attachment clutch engaged a few 
minutes after each use to free unit of any 
loose or melting snow.
Inspect unit for visible signs of wear, breakage 
or damage.
Keep all nuts, bolts and screws properly 
tightened and know unit is in safe working 
condition.
Store unit in a cool, dry protected area.

Clean unit thoroughly with mild soap and low 
pressure water and lubricate (see 
Maintenance). Touch up all scratched painted 
surfaces.
Remove weight from wheels by putting blocks 
under frame or axle.
When storing unit for extended periods of time, 
remove all fuel from tank and carburetor (run 
dry). Refer to Engine Manual.

WARNING: AVOID INJURY. Read 
and understand Storage Safety Rules 
in Safety section before proceeding.

1. Fuel tank is empty.
2. Build up of dirt and residue 

around governor/carburetor.

3. Key Switch not in run 

position.

4. Electric starter not 

functioning.

5. Engine ignition problems.

1. Fill fuel tank.
2. Clean area around governor/

carburetor.

3. Put Key Switch into run 

position.

4. Check for a bad starter or 

connections.

5. See Engine Manual.