Silex Technology SX-200 用户手册

 

 

Document #40181-420  Rev. A

 

10 

The print server includes the following components.  Detailed descriptions of these components are 
provided below: 

 

ƒ  Power connector – The power supply cable plugs into this connector. 
ƒ  Test button – Pressing this button for less than three seconds will print a test page on the printer.  

Pressing and holding this button for more than five seconds will reset the print server to factory 
default settings. 

ƒ  LED status indicators – used to indicate the operational states of the print server.  Refer to the LED 

status light descriptions on the next page. 

ƒ  Ethernet Port – This port is used for connecting the print server to a 10/100Base-TX Ethernet card, 

hub, router, or other wired access point for network access. 

ƒ  Parallel port – The parallel port is used for connecting the print server to the IEEE 1284-compliant 

parallel port of your printer (parallel port models only). 

ƒ  USB port – The USB port is used for connecting the print server to the USB 2.0 port of your 

printer.  You must use a standard USB A (print server side) to B (printer side) cable (USB port 
models only).