Silex Technology SX-200 用户手册

 

 

Document #40182-420  Rev. A 

 

62 

 
These commands set up the unit for performing an update of the server firmware. 

 

 
If enabled, the firmware performs a soft reset and enters the server boot program after the next EXIT command.   
This command should not be used with the Serial Server.  It remains in the firmware for diagnostic use. 
 

SET LOAd (ENable | DIsable ] 

 

(default = disable) 

 
 

 

Set the node name of the Netware boot host.  Note that netware download is not supported on the Serial Server, so 
this command should not be used. 
 

SET LOAd HOst      <name> 

 

(default = <null>) 

 
 

 

Set the IP address of the source computer for a TFTP get operation.  

 

SET LOAd IP   aa.bb.cc.dd 

 

(default = 0.0.0.0) 

 
 

 

Set filename on host for TFTP get update. 

 

SET LOAd SOftware  <filename> 

 

 

 
 

 

Initiate firmware update via a TFTP get operation.  The TFTP server address must be set via SET LOAd IP and the 
filename via SET LOAd SOfware.  The server will reset after the firmware update is completed.   

 

SET LOAd TFTP 

 
 

 

Initiate firmare update via the serial console using the  XModem protocol.  The server will reset after the firmware 
update is completed. 
 

SET LOAd XModem