Shindaiwa T10911001001 用户手册

 

7

With the unit on a clean, flat sur-

1. 

face, loosen the coupler screw. The 

spring-loaded coupler protector 

should pop up.
Press down on the latch with your 

2. 

finger or thumb. This releases the 

coupler lock. 
Pull the upper tube assembly out of 

3. 

the coupler.

Slip off the protective plastic covers 

2. 

from the ends of both tubes, and 

loosen the coupler screw knob.
Insert the tool assembly into the 

3. 

coupler, with the tool decal facing 

up, until the line of the decal is flush 

with the end of the coupler. 
Twist the tool assembly back and 

4. 

forth until you are sure it snaps in 

place by the coupler latch.
When the two tube halves are 

5. 

locked together, press down on the 

spring-loaded latch protector and 

tighten the coupler screw knob.

Place powerhead/lower tube 

1. 

assembly on a clean, flat surface so 

that both assemblies fit end to end.  

The powerhead/lower tube assem-

bly should be facing positioned with 

the locking hole in the tube end fac-

ing up. 

CaUTiOn!
Keep the open ends of the tubes 

clean and free of debris!

Strap and Hanger 

Although a strap and hanger is not 

required for use with this unit, it is  rec-

ommended to reduce operator fatigue 

during extended periods of opera-

tion.  Make sure all hooks and adjusting 

devices are secure. Adjust the harness 

shoulder strap so the shoulder pad rests 

comfortably on the off-side shoulder.