Ariens 21547000 用户手册

OPERATOR’S POSITION (See Fig. 1)

When right or left hand is mentioned in this manual, it

means when you are in the operating position (standing

behind tiller handles).

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard

wrench sizes are listed.
(1) Utility knife
(1) Tire pressure gauge
(1) Pair of pliers
(1) 9/16" wrench

Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes.

To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use

the correct tools as necessary to ensure proper tightness.

Fig. 1

Fig. 2

FRONT

OPERATOR’S

POSITION

LEFT

RIGHT

ASSEMBLY

HANDLE

ASSEMBLY

SHIFT ROD

UNPACKING CARTON (See Fig. 2)

CAUTION: Be careful of exposed

sta ples when handling or disposing of

cartoning material.

IMPORTANT: WHEN UN PACK ING AND AS SEM BLING TILLER,

BE CAREFUL NOT TO STRETCH OR KINK CABLES.

•

While holding handle assembly, cut cable ties se cur ing

handle assembly to top frame. Let handle assembly

rest on tiller.

• Remove top frame of carton.
• Slowly ease handle assembly up and place on top of

carton.

• Cut down right hand front and right hand rear cor ners

of carton. Lay side carton wall down.

• Remove packing material from handle assembly.

(1) Hairpin Clip

(1) Carriage Bolt

3/8-16 UNC x 1 Grade 5

(1) Center Locknut

3/8-16 UNC

(1) Handle Lock Lever

(1) Flat Washer 13/32 x 1 x 11 Gauge

CONTENTS OF HARDWARE PACK

(2) Handle Locks

(1) Pivot Bolt
3/8-16 UNC Grade 5

Extra Shear Pins & Clips